[Error Code] c402 on 2035 aficio

[akbareshghi]

Error C402 was appeared on my machine
please the causes of above error
in manual :
High voltage supply board defective
Transfer connector cable defective
Transfer connector defective
Poor PCU connection
please giude me about troubleshooting this problem
thanks you

[TonerMunkeh]

Re: c402 on 2035 aficio

Try the contact belt transfer clutch.

[akbareshghi]

Re: c402 on 2035 aficio

Try the contact belt transfer clutch.

what is your mind of Contact belt transfer clutch
in the following pic the section 9 is Transfer Unit Clutch
please guide me about open back door and how to clean this contact belt transfer clutc
thanks a lot

[lupi]

Re: c402 on 2035 aficio

Error C402 was appeared on my machine
please the causes of above error
in manual :
High voltage supply board defective
Transfer connector cable defective
Transfer connector defective
Poor PCU connection
please giude me about troubleshooting this problem
thanks you

	[Symptom] The transfer belt left solenoid connector is broken and causing SC402 (Transfer Output Abnormal Release Detection) to appear. SC402 (Transfer Output Abnormal Release Detection) appears. The transfer belt release solenoid remains off during copying. Replacement of the transfer belt release solenoid solves the problem, but the same problem occurs after several days of use with the new part. After AOF operation and switching off the machine at the operation panel, the solenoid switched on after 3 sec. and remained on. The solenoid remained on for a long time, causing the temperature of the solenoid to rise and blow fuse inside the solenoid. [Cause] The PFC board is defective. The machine is operating incorrectly due to a short circuit at a terminal on the PFC.
	Answer
	Replace the PFC Board. The terminal itself has been used previously in other machine, so the problems seems not to be expanded.

[lupi]

Re: c402 on 2035 aficio

Error C402 was appeared on my machine
please the causes of above error
in manual :
High voltage supply board defective
Transfer connector cable defective
Transfer connector defective
Poor PCU connection
please giude me about troubleshooting this problem
thanks you

Subject: SC402 and image on the paper is light Problem: The LD135 generates an SC402 error when ever you run a copy. The image on the paper is washed out but is okay on the drum

Cause:

Missing one of the two springs on the machine used for the transfer belt assembly

Solution:

[akbareshghi]

Re: c402 on 2035 aficio

i cleaned both Rear terminal and Bias terminal in transfer unit and Terminal spring in registration and sc402 is solved
thanks a lot