HI all.
Anyone out there had a PCU fail on a new machine (1600 prints) leaves a grey band down one edge (short edge) in feed direction,
i split the upper PCU and band was round charge roller also a line of coating worn off drum at edge of blade on opposite end.
I cleaned the charge roller and blade reassembled the unit and it seemed fine but customer phoned next day to say fault is back.
Any help appreciated.
Anyone out there had a PCU fail on a new machine (1600 prints) leaves a grey band down one edge (short edge) in feed direction,
i split the upper PCU and band was round charge roller also a line of coating worn off drum at edge of blade on opposite end.
I cleaned the charge roller and blade reassembled the unit and it seemed fine but customer phoned next day to say fault is back.
Any help appreciated.
Comment