C2050 bending original corners

[Jomama46]

I have a couple of these machines that are bending the rear corner of the original on a regular basis. Especially when scanning, faster scan I guess. Are there any bulletins on this subject or does anyone have any suggestions?
Edit: actually one of them is a c2051. Different Doc.

[sharpmind]

Re: C2050 bending original corners

I have a couple of these machines that are bending the rear corner of the original on a regular basis. Especially when scanning, faster scan I guess. Are there any bulletins on this subject or does anyone have any suggestions?
Edit: actually one of them is a c2051. Different Doc.

I fixed that problem by putting a small piece of double-sided tape under the rear side of the scale/ruler. Paper folds while traveling in that path because the scale is not on its desired height.

[Jomama46]

Re: C2050 bending original corners

Hmm, thats a good thought, you're talking about the one to the left of the scan glass, right? Thanks sharpmind.

[sharpmind]

Re: C2050 bending original corners

Hmm, thats a good thought, you're talking about the one to the left of the scan glass, right? Thanks sharpmind.

You're right.The scale with small exposure glass.

[TCA TECH]

Re: C2050 bending original corners

I have packed up the hinge springs to put more pressure on, fixed it for me

[zed255]

Re: C2050 bending original corners

I've put 'spacers' (truth be told some self adhesive velcro pieces) to prop open a little more the guide that receives the original back into the DF after passing the slit glass.

[Jomama46]

Re: C2050 bending original corners

I have packed up the hinge springs to put more pressure on, fixed it for me

Can you expand on that, I don't follow.

[granata]

Re: C2050 bending original corners

Hello I solved by putting a shim between the spring and the screw that presses the hinghe, same problem solved on 3030 df mpc2800