If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Ive been working it as a hard wired connection. I also took pix with my phone of the Interface pages in UT on a good machine and will compare them. Good thought.
sigpic
You never realize how cheap a professional is until after you let an amateur do it.
A+; Network +; PDI+
Finally solved, on page 2 of the UT interface settings is 802.11 Authentication. it was set to Active. Made it inactive and it picked up an address and I was able to print to it.
If I had a brain I would have simply cleared the UT settings with the # key. Thanks for all the help.
sigpic
You never realize how cheap a professional is until after you let an amateur do it.
A+; Network +; PDI+
Finally solved, on page 2 of the UT interface settings is 802.11 Authentication. it was set to Active. Made it inactive and it picked up an address and I was able to print to it.
If I had a brain I would have simply cleared the UT settings with the # key. Thanks for all the help.
That's twice you've had that now. Was it the same machine by any chance, as per this thread?
OMG, I dont even remember that machine or problem (obviously). No, different customer, This one was purchased from a wholesaler in CA.
I guess I have a serious case of CRS (cant remember shit).
sigpic
You never realize how cheap a professional is until after you let an amateur do it.
A+; Network +; PDI+
Comment