aficio 2035

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • vargue
    replied
    Re: aficio 2035

    thanks . i met that threat many times no problem .it's always reflection angel is need to correct or prepared variable resistors.some times synchro detector board is too filthy.but problem in customer didn't explain threat well.

    Leave a comment:


  • nmfaxman
    replied
    Re: aficio 2035

    322 C 1st laser synchronization error
    The 1st laser synchronization signal
    cannot be detected by the main scan
    synchronization detector board even
    if the laser diodes are activated.
    Poor I/F harness connection between
    the laser synchronization detector
    board and the LD unit.
    Laser synchronization detector board
    out of position and angle of reflection
    not correct
    Laser synchronization detector board
    defective
    LD unit defective

    2nd laser synchronization error
    The 2nd laser synchronization signal
    cannot be detected by the main scan
    synchronization detector board even if
    the laser diodes are activated.
    Poor connection between the laser
    synchronization detector board and
    the LD unit.
    Laser synchronization detector board
    out of position
    Laser synchronization detector board
    defective
    LD unit defective

    Have you run....

    LD Power Adjustment Adjusts the intensity of the laser for the copier,
    printer, and fax unit. The Copier and Printer/Fax
    settings can be adjusted separately.
    2103
    5* LD1 Adjustment Start/End
    2103*
    6* LD2 Adjustment Start/End
    (–50 ~ –35 / –45 /1 LSB step

    Leave a comment:


  • Tonerbomb
    replied
    Re: aficio 2035

    you got a laser problem. Before you pull that laser, with the 2 codes I'ld check the door switches!!!!

    Leave a comment:


  • vargue
    replied
    Re: aficio 2035

    thanks . customer tell me now sc322 revealed also 326 .

    Leave a comment:


  • Shadow1
    replied
    Re: aficio 2035

    Originally posted by vargue
    massage appeared on screen functional problem please restart can any one help what' causes this message
    It could be anything. What is the SC code?

    For example SC350 is likely a bad toner hopper, SC53x 54x and 55x are all fuser related, and 7xx would be the finisher or other accessories.

    Leave a comment:


  • JustManuals
    replied
    Re: aficio 2035

    This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from

    Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads


    Paul@justmanuals.com

    Leave a comment:


  • TonerMunkeh
    replied
    Re: aficio 2035

    Enter SP modes and look at the SC code that's causing the restart, that'll tell you what's causing it.

    Leave a comment:


  • vargue
    started a topic [Misc] aficio 2035

    aficio 2035

    massage appeared on screen functional problem please restart can any one help what' causes this message
Working...