Condensation issue in MP7000

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • Polarbear
    replied
    Re: Condensation issue in MP7000

    Great to hear that all is well again!

    Leave a comment:


  • TCA TECH
    replied
    Re: Condensation issue in MP7000

    Thanks for all the replys

    After returning with dehumidifier installed in room for 2 weeks all moister was gone. Just the developer spill that customer thought was same issue. new dev and should be sorted.

    Leave a comment:


  • Polarbear
    replied
    Re: Condensation issue in MP7000

    Just a question about the tray heaters - those work (on most models) when the machine is OFF and not when the machine is ON. I have heard of condensation issues on machines in confined spaces when they do long runs.

    We have a few PRO 907, and 1307 that do long runs and you also see similar if there is not adequate ventilation.

    Leave a comment:


  • Eric1968
    replied
    Re: Condensation issue in MP7000

    Are you sure moisture is the cause of this blur? The air from an airconditioner is dry air, so maybe the cause of the blur should be found somewhere else.

    Just my 2 cents...

    Leave a comment:


  • JustManuals
    replied
    Re: Condensation issue in MP7000

    This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from


    Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


    Paul@justmanuals.com

    Leave a comment:


  • Polo-022
    replied
    Re: Condensation issue in MP7000

    I have had the same issue on a same model MP 7000...
    After too many visits and adjustments about fuser idling, transfer & clean. blade pattern forming on drum (SP 2940, 2964,2966) etc.. last thing left was to totally disconnect drum & paper trays heaters!! (No call back since then...3 months ago)
    The above procedures (SP adj.) worked on AF-2051/2060/2075...

    Leave a comment:


  • TCA TECH
    started a topic [CQ] Condensation issue in MP7000

    Condensation issue in MP7000

    Hi all,
    Need your ideas,
    have a mp7000 that is in a small room that is airconditioned and get lots of moisture about the fuser unit and drips on to the drum causing a blurr affect, by 100am is it preaty much gone. Customer has same machine upstairs in a bigger room no issue.
    Heaters on in trays
    Set to turn on at 7.ooam to try and warm up
    no we close the door and run a deumidifier

    Just goes away after a lot of sun shine but returns when wet, never an issue on previous AF5051.

    Idea's please
    Thanks in advance
Working...