I have a C901 showing "fusing unit not set correcly" The error came after reboting machine. The machine is almost new. I've tried 2 different fusers.
Contacts are clean and ok. I have read the temperature of the thermistors in the service mode. It seems like the machine is in contact with them at least.
I've seen point to point diagram. anyone know what FU_ID_BIT and connect are doing in the fuser ? Anyway, I have tried 2 different fuser units..
So I do not think the fault may lie where.. What is the next step ? Switch IOB 2 card ?
I apologize for poor English
Mente du: ber om unnskyldning for
Contacts are clean and ok. I have read the temperature of the thermistors in the service mode. It seems like the machine is in contact with them at least.
I've seen point to point diagram. anyone know what FU_ID_BIT and connect are doing in the fuser ? Anyway, I have tried 2 different fuser units..
So I do not think the fault may lie where.. What is the next step ? Switch IOB 2 card ?
I apologize for poor English
Mente du: ber om unnskyldning for