MP3352

[tludden]

I have an MP3352 getting light washed out looking copies. Prints look fine. I did drum, developer, primary and SP2801 but no luck still washed out looking. I have the primary for copying maxed out just to make the copies look good??

Any suggestions?

Thanks

[ruben]

Re: MP3352

If prints look good, I would focus on scanner optics.

[sandmanmac]

Re: MP3352

x 2 on the scanner optics. You didn't mention doing them, and that should be the first thing you do when prints are fine and copies washed out. It's certainly not a dev/drum problem if prints are ok

[tludden]

Re: MP3352

I did clean the optics. I am ordering a LED assembly hoping that will do it.

Thanks

[Bantams]

Re: MP3352

If its somewhere really Cold it could be condensation building up in the Optics If that's the case its going to need the anti condensation heater fitting.

[kannuki2]

Re: MP3352

Try to make a copy in 50% reduce and enlarge images to see if the density changes. It could be a tilt in the optic mirror.

[Ollie1981]

Re: MP3352

Run Sp5990 - 06 Non Default and compare all values with the "Birth Certificate" which if you are lucky should be under the laminated card in the front door.

Had this problem a couple of times where the scanner gamma settings were all out of whack, dunno why, but re-inputting the values on the birth certificate brought the CQ back.

If it keeps forgetting them, it'll need an NVRAM