[Misc] refill fuser oil in a 2238c.

[zflash7]

I have 3 of theses units (Ricoh 2238c) and use them as mass flyer printers. I dont want to blow any more fusers. But I do want to refill the oil units. I have the DIMETHYLPOLYSILOXANE all I want to do is pour it in the unit. per-say
I have the will. does anyone know of the way?
RE: Z.

[rthonpm]

Re: refill fuser oil in a 2238c.

The easiest and most effective way is:

Lanier LD232C Fuser Oil Unit, Genuine (A4215)

or

https://www.gmsparts.com/product_detail/b81bc10cdf7b66f725ddbafacc730ad3/Fuser_Oil_Unit

Trying to refill these is pretty much the best way to get yourself a blown fuser or a really slick floor.

[sandmanmac]

Re: refill fuser oil in a 2238c.

I have 3 of theses units (Ricoh 2238c) and use them as mass flyer printers. I dont want to blow any more fusers.

Then replace the oil units as suggested. Problem (and MESS) resolved.

[neergish]

Re: refill fuser oil in a 2238c.

Are you using the high capacity Oil Unit B149 9500? Might make things easier on your fusers if your doing high volume.

[Tonerbomb]

Re: refill fuser oil in a 2238c.

I have 3 of theses units (Ricoh 2238c) and use them as mass flyer printers. I dont want to blow any more fusers. But I do want to refill the oil units. I have the DIMETHYLPOLYSILOXANE all I want to do is pour it in the unit. per-say
I have the will. does anyone know of the way?
RE: Z.

A really bad idea that will go wrong............

[zflash7]

Re: refill fuser oil in a 2238c.

I've been a rebel all my life so I'm going to try it anyhow.
The hole is small and last time I spilled a bit this time I'm using a squeeze gun nozel and will pour in 50mm at a time, 400mm refill should take roughly 1/2 hour.

..............Rebel for life.....................though it may be short.

[JustManuals]

Re: refill fuser oil in a 2238c.

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads



Paul@justmanuals.com

[thierry]

Re: refill fuser oil in a 2238c.

I have 3 of theses units (Ricoh 2238c) and use them as mass flyer printers. I dont want to blow any more fusers. But I do want to refill the oil units. I have the DIMETHYLPOLYSILOXANE all I want to do is pour it in the unit. per-say
I have the will. does anyone know of the way?
RE: Z.

Not a good idea. But if you are a rebel then do not forget to replace the fuse on the oil supply unit so that the machine can detect that "you" have replaced the unit. Secondly i would also look at the long life oil supply unit and also increase the value of your oil supply unit through SP 7905-14.

But good luck!

[zflash7]

Re: refill fuser oil in a 2238c.

I was going to re-set the fuser oil, replace the fuse?. OK if I can find one. Thanks.