I have an LD090 and copies started coming out with a black streak on the front edge. I noticed that toner is spilling between the developer and drum housing. I replaced developer and changes blade. Please help rectify this problem.
PLEASE HELP? Aficio 2090 Toner streaking issue
Collapse
X
-
-
Re: PLEASE HELP? Aficio 2090 Toner streaking issue
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.com -
Re: PLEASE HELP? Aficio 2090 Toner streaking issue
Anyway, that's the best I can do with the information you shared, so good luck!Comment
-
Re: PLEASE HELP? Aficio 2090 Toner streaking issue
What is the print count? You might want to swap out the developer unit if the count is pretty high (no need to have spilling developer wipe out the feed clutches, I've never had to replace them, but it doesn't sound like a whole lot of fun). Or, if there was just a big pile of only toner in the left hand side of the drum unit frame, and you vacuumed it out then changed the developer according to the procedure in the manual, you might be OK. Might not hurt to keep an eye on the condition of the seals in the drum/developer area, too.
Anyway, that's the best I can do with the information you shared, so good luck!
Will Try this. And post resultsComment
-
Re: PLEASE HELP? Aficio 2090 Toner streaking issue
bye"Who loves the roses,must also bear thumbs"Comment
-
Re: PLEASE HELP? Aficio 2090 Toner streaking issue
Attached is the copies coming out. The streak is toward the front of machine. on 8.5 x 11. Tries 100 copies and same results. Just stays te same or a little darkerIMG_20130124_175853.jpgComment
-
Re: PLEASE HELP? Aficio 2090 Toner streaking issue
Enter Sp Mode 2001-3 and change value to 1300 and print a copy of copycounter and see the result.
I think its just a corona charge problem.
Show me results plz
Did you tried SP2801 and SP2962 after changed the developer??"Who loves the roses,must also bear thumbs"Comment
-
Re: PLEASE HELP? Aficio 2090 Toner streaking issue
This issue has got nothing to do with drum or dev units.
It's your transfer unit, pull the unit apart and check the earths on the bias roller and connections to the transfer bias board in the unit its self. More than likely the board is starting to fail, so just replace the whole transfer unit.Comment
-
Re: PLEASE HELP? Aficio 2090 Toner streaking issue
looks like typical corona wire dirty..
try a pencil erasure across the wire and clean the grid wth soap and water and dry well..Comment
-
Re: PLEASE HELP? Aficio 2090 Toner streaking issue
We just replaced the wires and grid. Looked good for a little whileComment
-
Re: PLEASE HELP? Aficio 2090 Toner streaking issue
also check your air pump is working. the hose can plug between the developer housing and the pump to the waste toner bottle. no air displacement will cause toner to be forced out at the add point which is at the front of the DV unit.Comment
-
Re: PLEASE HELP? Aficio 2090 Toner streaking issue
Attached are pictures I took. Of where the toner is collecting it looks as I do prints to be coming out of the small hole right to the springUntitled-4.jpgUntitled-5.jpgComment
-
Re: PLEASE HELP? Aficio 2090 Toner streaking issue
You have problem with cleaning.
First check quenchin lamps(disscharge lamps) if they are dirty in that area of drum and if they are dirty,just clean them,otherwise change drum cleaning blade.
If this cant help,you have a bad drum.
Do what i said and do not ask anymore questions.
Bye"Who loves the roses,must also bear thumbs"Comment
Comment