MPC 300 SC240

[TonerMunkeh]

Re: MPC 300 SC240

Make sure you fit the modification too otherwise it'll just do it all over again. M026 9904.

[nkot^1]

[sandmanmac]

Re: MPC 300 SC240

Make sure you fit the modification too otherwise it'll just do it all over again. M026 9904.

I've just had this code pop up on a machine myself, and am away for a few days and unable to attend the call.
I have someone that can fit an LD unit for me, which sounds like the main problem.
My question is:
"Should" that resolve the problem temporarily (for a week or so) until I can get back and fit the Modification, or is the Power supply typically damaged and will take out the LD unit right away?

ALSO..any chance it coould just be a k- PCU? It is actually a bit overdue for one

Thanks!

[mikadonovan]

Re: MPC 300 SC240

"Should" that resolve the problem temporarily (for a week or so) until I can get back and fit the Modification

It should Sandy, it has for me. After eating the cost of a new LD unit a couple of times, I went ahead and put the mod on all my c300's in the field.

[sandmanmac]

Re: MPC 300 SC240

It should Sandy, it has for me. After eating the cost of a new LD unit a couple of times, I went ahead and put the mod on all my c300's in the field.

Thanks Mika!
Replacing the LD unit has fixed it for now. I'll decide what to do when I get back.
I had a parts machine to harvest from, but I'm also lucky that I live so close to a massive machine wholesaler that's very good to me when I need replacement parts like that.