[Misc] Nashuatec MP2000 - Skew image

[brunot]

Dear All
When i use the scanner or ADF unit to make a copy,i have a skew image.
The counter print is ok and the image is well aligned on the drum.
I have also replaced the clutch,the front and rear bushings of the registration roller.
Please adviced.
Thanks
Bruno

[rthonpm]

Re: Nashuatec MP2000 - Skew image

Lift up on the frame of the scanner unit from the front left side. It sounds like someone's been leaning on the op panel and shifted it.

[brunot]

Re: Nashuatec MP2000 - Skew image

Well noted
Thanks
Bruno

Lift up on the frame of the scanner unit from the front left side. It sounds like someone's been leaning on the op panel and shifted it.

[Eric1968]

Re: Nashuatec MP2000 - Skew image

You can also remove the right screw of the right adf hinge, and put it in the larger hole right next to the original hole. Then you can adjust the adf position.

[Polarbear]

Re: Nashuatec MP2000 - Skew image

A quick check to see df to scanner alignment, is to look down the right side of the scanner housing. The df should line up with the scanner frame - if it is skew, you will see it straight away. The hinges on these dfs are not the strongest, and can bend should someone move the machine by shoving the df.

[JustManuals]

Re: Nashuatec MP2000 - Skew image

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com