mp5500 goes to sc181 after close adf

[ponto700]

Hi,

today i turn on my mp5500 but after few seconds the machine gives sc181. but if i turn on with the adf open the machine works fine. i can take copies from exposure glass.
did anyone already had this problem before?

[HP:guy]

[JustManuals]

Re: mp5500 goes to sc181 after close adf

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com

[TonerMunkeh]

Re: mp5500 goes to sc181 after close adf

When the doc feeder is closed, the machine attempts to get the white reference from the df slit glass plate and the CIS white reference roller. As per the previous post, either the roller is manky or the CIS itself has failed. If so, change it, it's stabiliser board and harness as a set.

[ponto700]

Re: mp5500 goes to sc181 after close adf

many thanks for replays... after i remove cis anc clean all and clean also the white roller i test machine and no more sc code.