C3500 streaks on front edge

[Iowatech]

Re: C3500 streaks on front edge

Is the ITB cleaning assembly in good shape?

[tinfox]

Is the ITB cleaning assembly in good shape?

I put a new one in.

[CableGuy]

Re: C3500 streaks on front edge

Temperature can cause these lines to appear and then vanish as the machine and surroundings warm up, I've have had it many times.
If you look on the SMC you'll find the drum units around or over their life. You can clean the Charge rollers if you have the old type drums in there, it's bit more of a ball ache to clean the modified drums. So I would suggest replacing the affected drums and hope for warmer weather.....

[tinfox]

Temperature can cause these lines to appear and then vanish as the machine and surroundings warm up, I've have had it many times.
If you look on the SMC you'll find the drum units around or over their life. You can clean the Charge rollers if you have the old type drums in there, it's bit more of a ball ache to clean the modified drums. So I would suggest replacing the affected drums and hope for warmer weather.....

That's interesting... Has anyone else experienced this?

Also is there any place to get just the blades?

[CableGuy]

Re: C3500 streaks on front edge

I'm not aware that you can get individual parts for these, you could try Katun. But if that's the route you are going down you're only making more problems for yourself. Bite the bullet and replace the unit with OEM parts, that'll make for an easier life for yourself

[tinfox]

Re: C3500 streaks on front edge

I'm not aware that you can get individual parts for these, you could try Katun. But if that's the route you are going down you're only making more problems for yourself. Bite the bullet and replace the unit with OEM parts, that'll make for an easier life for yourself

I already ordered pcus. I just want to experiment. I can't help myself...

[mabawser]

Re: C3500 streaks on front edge

That's interesting... Has anyone else experienced this?

Also is there any place to get just the blades?

my company did get a katun kit with a drum and a blade in it but they were not worth a shit. 99% of the time its the charge rollers anyway

[checks]

Re: C3500 streaks on front edge

had a similar problem ,and after reading all the post here, decided to clean all the charge rollers.Bingo it worked beautifully. I used Katun drum and blade they are not first rate but not all bad

[Eric1968]

Re: C3500 streaks on front edge

Take a look at the PM Counters. These PCU's last for 80k. Cleaning the Charge Rollers is a temporary measure.

[AlanHubb]

Re: C3500 streaks on front edge

100% Charge rollers for me this.

did the New PCU units sort the problem out?

if so. rip apart the old units, and you should clearly see the charge roller lines. (you probs done this already).

oh and dont forget the SC 3902 PCU resets lol.

[qbert69]

Re: C3500 streaks on front edge

NuFinish.jpg

http://www.nufinish.com/products/car-polish

POLISH YOUR JOHNSON RODS!!!


LOL!!!