If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
well as i like to mcgyver things
on the mpc2800 a mpc3000 toner is "almost" identical..
as i have/had no use for two mpc3000 black toners i tried to make it fit.
the front plastic needed some trimming and it went in but the machine doesnt see it..
a different chip.
i get the feeling the toner is the same but wont go any further.
if it contaminated the dev unit i would eat a bag of developer just to know..
Go figure...it doesn't fit and it's a different chip.
I knew there was a reason I simply use the right toner in the right machine
Can't think of any good reason not to.
The 28 and 33 are the same but the 3000 is an older and different animal
well as i like to mcgyver things
on the mpc2800 a mpc3000 toner is "almost" identical..
as i have/had no use for two mpc3000 black toners i tried to make it fit.
the front plastic needed some trimming and it went in but the machine doesnt see it..
a different chip.
i get the feeling the toner is the same but wont go any further.
if it contaminated the dev unit i would eat a bag of developer just to know..
can anyone advise me if these toners are interchangeable?
i was under the impression they are but got a call im going to go to and was looking
for info
thnx
Leave a comment: