MPC 4000 color registration failed

[Bole]

Hi,

I have problem with color registration on MPC 4000. The problem is in this that is appearing approximately occasionally on 14 days.
Usually it is not enough to switch ON/OFF, I must to do the SP2-111-3 and SP2-111-1. After that the copier works normaly a few next days.
I already was cleaning laser unit and the ITB looks ok.
Did someone had analogous problems???

thank you for your cooporation

Bostjan

[slimslob]

Re: MPC 4000 color registration failed

Hi,

I already was cleaning laser unit and the ITB looks ok.
Did someone had analogous problems???

thank you for your cooporation

Bostjan

Have you cleaned the density sensor assembly. It can cause the color registration to go off.

[Eric1968]

Re: MPC 4000 color registration failed

Only magenta is off. Replace the magenta PCU. Maybe the drum is not rotating at the proper speed.

[joshuadenmark]

Re: MPC 4000 color registration failed

1. Clean MUSIC sensors.

2. Check toner density, too low cause color reg to fail.

[walterman]

Re: MPC 4000 color registration failed

I know this is an old thread, however, it helped me out. I cleaned the music sensors and the mfp color reg. was fixed, thank you!

[joshuadenmark]

Re: MPC 4000 color registration failed

I know this is an old thread, however, it helped me out. I cleaned the music sensors and the mfp color reg. was fixed, thank you!

Thanks for you feedback, always nice to hear the results.

[sandmanmac]

Re: MPC 4000 color registration failed

Thanks for you feedback, always nice to hear the results.

Very true. Wouldn't it be nice if the original poster would show the same courtesy and appreciation?

[Tonerbomb]

Re: MPC 4000 color registration failed

I know this is an old thread, however, it helped me out. I cleaned the music sensors and the mfp color reg. was fixed, thank you!

LIKE !!!

[imihm]

Re: MPC 4000 color registration failed

LIKE !!!

Hi there...
Perform clear all,then run line positioning...

Thanks...

[Polarbear]

Re: MPC 4000 color registration failed

Hi there...
Perform clear all,then run line positioning...

Thanks...

imihm a word of warning. Never advise someone working on a colour box to do a memory all clear.
That NEVER has and NEVER will fix the problem - in fact it wil create MORE problems.

Stuff like line position errors have a cause. One needs to find the cause and fix it - Memory all clear is NEVER a fix!

[bob marley]

Re: MPC 4000 color registration failed

Hi there...
Perform clear all,then run line positioning...

Thanks...

wrong

[M0scb]

Re: MPC 4000 color registration failed

As said before, I know this is an old thread. I have had an issue where the speed encoder in the transfer assy had failed. At the time of running the music adjustment, it would compensate. Over time, the belt drive was slipping, causing registration to move. As the encoder is not avaliable as a spare part the only option, for me at least, was to replace the transfer assy. The fault never returned.

[alistair]

Re: MPC 4000 color registration failed

Thanks for you feedback, always nice to hear the results.

Hi
Can anyone tell me how to reset the color registration, all three colors are way out on an MP C4000.

[lawchatkui]

Re: MPC 4000 color registration failed

Hi pro, where is the density & music sensor?

Sent from my Mi 4i using Tapatalk

[Llama God]

Re: MPC 4000 color registration failed

Hi pro, where is the density & music sensor?

Sent from my Mi 4i using Tapatalk

Tit