ricoh cl4000 dn Replace Inttrans Unit message will not clear

[walterman]

I just replaced the transfer belt on a Ricoh CL4000DN. I made sure the printer was unplugged, power and interface cords, I installed the belt, plugged the printer back in. The printer still has the message? Pardon my ignorance, however, I was expecting the printer to "reset" the count. How do I reset the count manually? Thank you.

[sandmanmac]

Re: ricoh cl4000 dn Replace Inttrans Unit message will not clear

I believe it generally does reset automatically, but if not, then you can reset with SP Mode 7804-009

[Counsel]

Re: ricoh cl4000 dn Replace Inttrans Unit message will not clear

Pretty sure on that one you hold the up and down buttons for like 5 seconds, then release and hit OK/Enter button should give you a Service ? Engine/ End menu, choose engine for SP mode

[slimslob]

Re: ricoh cl4000 dn Replace Inttrans Unit message will not clear

Pretty sure on that one you hold the up and down buttons for like 5 seconds, then release and hit OK/Enter button should give you a Service ? Engine/ End menu, choose engine for SP mode

That is method 2 for use when the machine is already on. If the machine is off press and hold the "On Line" key and the "Escape" key together while turning on the power.

[walterman]

Re: ricoh cl4000 dn Replace Inttrans Unit message will not clear

Thank you for all the information. I was able to clear the message; however, (lol) I found pressing the on line and escape buttons, simultaneously, damn near impossible, my fingers are still cramped from stretching, moreover, the issue is resolved.