MPC 6501 - Finisher not detected after firmware update

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • rpr383
    Technician
    • Apr 2010
    • 14
    #16
    Re: MPC 6501 - Finisher not detected after firmware update

    6501 never came with SOP,and on 6501 once you load the wrong firm on the fin cont you cant just reload the correct firm. The mach dosent know there is a finisher. so you have to replace. Ask me how I know!

      Comment

      • Debs1964
        Service Manager

        1,000+ Posts
        • Oct 2010
        • 1687
        #17
        Re: MPC 6501 - Finisher not detected after firmware update

        Originally posted by rpr383
        ...Ask me how I know!
        OK, I'll play along...how do you know
        There are 10 types of people in this world, those who understand binary maths and those who don't

          Comment

          • slimslob
            Retired

            Site Contributor
            25,000+ Posts
            • May 2013
            • 36902
            #18
            Re: MPC 6501 - Finisher not detected after firmware update

            Originally posted by rpr383
            Ask me how I know!
            Originally posted by Debs1964
            OK, I'll play along...how do you know
            Sounds to me like the voice of been there done that.

              Comment

              • rpr383
                Technician
                • Apr 2010
                • 14
                #19
                Re: MPC 6501 - Finisher not detected after firmware update

                Originally posted by Debs1964
                OK, I'll play along...how do you know
                Yes that was this guy, I failed on this once.

                  Comment

                  • pajonk
                    #20
                    Re: MPC 6501 - Finisher not detected after firmware update

                    Originally posted by rpr383
                    6501 never came with SOP,and on 6501 once you load the wrong firm on the fin cont you cant just reload the correct firm. The mach dosent know there is a finisher. so you have to replace. Ask me how I know!


                    Hi
                    just have above issue with finisher. Can I ask you to tell me how to sort this problem?
                    order new pcb or can I swap from scrap fin?

                      Comment

                      Previous 1 2 template Next
                      Working...