Pro C700ex color reg issues

[digicor]

Ive ran the 2111 on this thing and the user maint clr reg comes back complete yet , the color and the blk are still out by about 1/6th or less where is the man line adjustment? on this machine, i dont deal with these too often
update
apparently there is no auto line correction on these,
I must go back to the old days, any one have a fax machine and a dial tone and some paper on a roll....
You MUST do sp 2109-2 pattern 1 then YOU MUST own a loop, i have one, and go through 2101-002/003/004/013/014 015 this is only way to achieve great line correction grasshopper
No wonder no one wants these beasts.. it does i may say have great color quality and density . just not all on the same line...LOL

[slimslob]

Re: Pro C700ex color reg issues

dirty ID sensors can throw these adjustments off. When you run Forced Line Position, execute 2111-003 first, then run 2111-001 or 2111-002 twice.

[digicor]

Re: Pro C700ex color reg issues

I have just found out , but there is no 2111- anything its only 2111, i have to do it from 2101-*** manually

[digicor]

Re: Pro C700ex color reg issues

well ok i did the man line by effin line grid calibration, the colors are terrific!
my eye hurts from looking through a loop for an hour LOL but in the end i dont have to LUG that machine to the dump!! hahahah
and replace it.
sp2101-1,2,and3 for about an half hour or so, it was way out , then 2111 then user color reg and its magnificent the colors are really nice and not in 3D...

[slimslob]

Re: Pro C700ex color reg issues

I have had to do the manual grid alignment a couple of time to get a machine to where 2111-003 did not error. Not a fun thing to do.