If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
when printing out logging info on SP print out the plotter info lists #14 & #67 with out telling area for misfeeds; could any one provide please and as to why the area is blank;
Thanks!!!
Description of jam locations are listed in SP 7504. If the description is blank, you may need to update firmware. In the service manual, J14 is listed as duplex exit sensor 3. J67 is not listed but J66 is duplex exit sensor 1 so 67 could also exit sensor 3.
Comment