Firmware

[trc]

[trc]

Re: Firmware

Sorry for the mistake, the MP 6001 with the Blown Finisher Board i is a SR 4030 finisher.....(not SR 4050)

[slimslob]

Re: Firmware

If everything else is the same on the boards, you will need to replace the EEPROM.

[trc]

[slimslob]

Re: Firmware

In that case, you will have to replace the board.

[donholl]

Re: Firmware

I am positive these boards/ finishers are not interchangeable, mechanically they are the same finisher; however, they changed from the e-prom style firmware in the SR 970, to the SD card update for firmware with the SR 4030, even in the SR 4030 you have to pay close attention to what style control board is in the finisher, as Ricoh changed vendors mid production and there are different firmware for each style board. Hope this helps

[Iowatech]

Re: Firmware

I am positive these boards/ finishers are not interchangeable, mechanically they are the same finisher; however, they changed from the e-prom style firmware in the SR 970, to the SD card update for firmware with the SR 4030, even in the SR 4030 you have to pay close attention to what style control board is in the finisher, as Ricoh changed vendors mid production and there are different firmware for each style board. Hope this helps

Yikes, I forgot all about the board change! Thanks for reminding me.