Samsung 6545 copier. When tray one tries to lift it raises for a couple seconds and then starts popping and continues to make the popping noise. Tray 2 works fine, so I inserted tray 2 into tray 1 slot to try out. It did the same, so I eliminated the tray and gears in the back of the tray as a possibility. Sounds like the tray is lifting into position but not stopping. Would it be the sensor below the paper lift motor that drives the gears on the tray, going bad? I hardly ever work on a Samsung and do not have a service manual for it. Thank you in advance for any advice.
Samsung 6545 paper tray lifting problem
Collapse
X
-
Re: Samsung 6545 paper tray lifting problem
Samsung 6545 copier. When tray one tries to lift it raises for a couple seconds and then starts popping and continues to make the popping noise. Tray 2 works fine, so I inserted tray 2 into tray 1 slot to try out. It did the same, so I eliminated the tray and gears in the back of the tray as a possibility. Sounds like the tray is lifting into position but not stopping. Would it be the sensor below the paper lift motor that drives the gears on the tray, going bad? I hardly ever work on a Samsung and do not have a service manual for it. Thank you in advance for any advice. -
Re: Samsung 6545 paper tray lifting problem
Flag is still there. The gears for the paper lift is on back of the tray and are good so I don't think it needs a new paper feed unit, but I don't work on Samsung that often and I'm not real familiar with themComment
Comment