If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
When machine is switched on there is a clicking noise in fuser area. Nothing else happens. No display or anything. Maybe power supply? Any ideas? Thanks.
When machine is switched on there is a clicking noise in fuser area. Nothing else happens. No display or anything. Maybe power supply? Any ideas? Thanks.
Remove the fuser and try to power on.
"You can't trust your eyes, if your mind is out of focus"--
I've had a couple of these. On one, Replacing the Fuser did the Trick. On the other, Replacing the Power supply did the trick. Try pulling the Fuser to see if it powers on. If not, I bet the PS is at fault.
Comment