Mxm453n grey background

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • SDtech619
    replied
    Re: Mxm453n grey background

    FIXED-UPDATE

    So it ended up being the development bias was way off. Used simulation 8-1 to fine tune it. Thanks guys!!

    Leave a comment:


  • SDtech619
    replied
    Re: Mxm453n grey background

    Thanks for the suggestions guys...I'll reply with fix once I figure it out. This equipment is in a prison and well I certainly don't want to go back there any time soon. Customer hasn't noticed but I want to address the problem before it gets worse. I'll be checking on it bent time I go in. Thx again!

    Leave a comment:


  • Jhonjon
    replied
    Re: Mxm453n grey background

    Originally posted by SDtech619
    Ok I'm chasing my tail here...the background is very slight when you do internal prints and of course it gets darker when making a copy. Replaced dev unit,dev,drum and transfer assembly...I may start shooting for a board?? Suggestions, please! Checked some AE sim...and some other density simulations...Thx ahead of time
    Correct me if I'm wrong the problem of your machine is overtone?! A lot of this machine i handle, overtone is one problem i frequently encountered. Replacing consumables resolve some of the issue but some problem I've encountered is cause by the user who want to save money by purchasing compatible toner. Some problem is the compatible upper fuser roller toner stuck to it...

    Leave a comment:


  • bilyahn
    replied
    Re: Mxm453n grey background

    drowranger is correct with this. Have had it happen a couple of times and both were caused by the charge unit. One of the instances was with a fairly low meter machine (50K).

    Good luck.

    Bil

    Leave a comment:


  • drowranger
    replied
    Re: Mxm453n grey background

    change the mc grid & drum blade first . can be either. then the process unit

    also check the sim 46-19 auto exposure gamma setting default is mode 2, mode 1 will make it darker

    Leave a comment:


  • SDtech619
    started a topic Mxm453n grey background

    Mxm453n grey background

    Ok I'm chasing my tail here...the background is very slight when you do internal prints and of course it gets darker when making a copy. Replaced dev unit,dev,drum and transfer assembly...I may start shooting for a board?? Suggestions, please! Checked some AE sim...and some other density simulations...Thx ahead of time
Working...