What parts do you usually replace in the FNX9 finishers?

[CCS]

I have some FNX9 finishers out there that the meters are getting up there, some intermittent jams.

What parts would you replace to refurb the FNX9 ?

I have not been inside one much yet but was going to order parts first before I tear one apart in the shop, thanks.

[sharphead]

Re: What parts do you usually replace in the FNX9 finishers?

Take a look at a particularly tired one. The exit roller towards the front will hang lower than the one towards the back. This is caused by too much play in the mechanism that lifts the rollers. Look at the tech bulletin to resolve this.

Apart from that I've had no problems and have a few pushing two million pages out.

[copytechonline]

Re: What parts do you usually replace in the FNX9 finishers?

Exit rollers X2 0CW4141P301//

Inner Roller X2 0CW4141P007//

Belt X2 0CW4141P372//

[CCS]

Re: What parts do you usually replace in the FNX9 finishers?

OK, Thanks alot.

[CCS]

Re: What parts do you usually replace in the FNX9 finishers?

Take a look at a particularly tired one. The exit roller towards the front will hang lower than the one towards the back. This is caused by too much play in the mechanism that lifts the rollers. Look at the tech bulletin to resolve this.

Apart from that I've had no problems and have a few pushing two million pages out.

I can't find or don't have access to this tech bulletin, could someone please post a link or pm me, thanks.