Sharp ARM 450 only rebooting

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • monham
    Technician
    • Jun 2012
    • 16

    #1

    Sharp ARM 450 only rebooting

    I have a sharp arm 450. when you turn it on, it just keep rebooting. I will appreciate the help.
  • spanky
    Trusted Tech

    250+ Posts
    • Sep 2012
    • 468

    #2
    Re: Sharp ARM 450 only rebooting

    Disconnect network cable and power up.
    If it does not reboot and copies then you have a bad print job in the queue that needs to be cleared.

    Comment

    • monham
      Technician
      • Jun 2012
      • 16

      #3
      Re: Sharp ARM 450 only rebooting

      Thanks for the help. However, the Sharp Arm 450 is not connected to the network it is being used as a stand alone copier. It was working fine then one day when it was turned on it just began rebooting.

      Comment

      • blackcat4866
        Master Of The Obvious

        Site Contributor
        10,000+ Posts
        • Jul 2007
        • 22997

        #4
        Re: Sharp ARM 450 only rebooting

        Have you monitored the power supply outputs? =^..^=
        If you'd like a serious answer to your request:
        1) demonstrate that you've read the manual
        2) demonstrate that you made some attempt to fix it.
        3) if you're going to ask about jams include the jam code.
        4) if you're going to ask about an error code include the error code.
        5) You are the person onsite. Only you can make observations.

        blackcat: Master Of The Obvious =^..^=

        Comment

        • lky1978
          Trusted Tech

          250+ Posts
          • Mar 2009
          • 482

          #5
          Re: Sharp ARM 450 only rebooting

          check for power supply capasistor , is it both 10v5600uf busrted

          Comment

          Working...