[Jamming] MX2301n

[mutumoja]

Random Jamming whilst doing multiple coping through the duplex unit only jam code APPD_1, already have removed exit assembly and checked both the sensor arms and Sims operation,but problem persists intermittently whilst duplexing

[ZOOTECH]

Re: MX2301n

Random Jamming whilst doing multiple coping through the duplex unit only jam code APPD_1, already have removed exit assembly and checked both the sensor arms and Sims operation,but problem persists intermittently whilst duplexing

It wasn't this model, but I did have a new set-up that the duplex motor on the right side door would sometimes reverse it direction, and cause this same code.

[JR2ALTA]

Re: MX2301n

Does that exit assembly have a oneway?

[mutumoja]

Re: MX2301n

have had the assembly out and all bearings are ok thanks

[mutumoja]

Re: MX2301n

have had the assembly out and all bearings are ok thanks

Sorry everyone I have solved the problem.just forgot to post again

Problem was the sensor arm in the gate leading into the duplex unit which was heat affected and had deformed to a point that it was touching the chassis of the gate thus slowing the reaction time of the sensor reaction causing the intermittent jam.
Thanks guys for the suggestions