MX1810U boot message

[glimmer1980]

Hi,

Does anyone know what the below message on a MX1810 would cause

Version check ICUB: W100G100

The MFP won't start after this message

Regards,

Ramon

[copyguy1]

Re: MX1810U boot message

Sounds like corrupt firmware. Try to do emergency update

[faxman28]

Re: MX1810U boot message

Hi,

Does anyone know what the below message on a MX1810 would cause

Version check ICUB: W100G100

The MFP won't start after this message

Regards,

Ramon

make sure the fw update switch on mfp control bd is off, that screen can come up when update switch is on(some call it emergency fw update). If the switch is off and you don't see the sharp boot screen , the sd card needs replacing as the boot program is on the sd card.

This function is used to revise the firmware by using the USB memory
for the MFP PWB, the SCU PWB, the PCU PWB, the FAX
PWB, and each option.
It is basically same as SIM 49-01, but differs in the following points.
1) The update target ROM is automatically selected.
2) When the power is shut down or an abnormality occurs in a
section other than the boot program for some reasons during
firmware update operation of other method than the CN
update.
If, however, an abnormality occurs in the boot program, this
method cannot be used. On that case, the SD card must be
replaced with a new one having the normal boot program.
When the boot animation is displayed but "Copying is enabled" is
not displayed on the copier basic menu, there is an abnormality in

the main program (SD card).

the main program (SD card).