Sharp MX6240N MX-FN19 Misfeed

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • buzz
    replied
    Re: Sharp MX6240N MX-FN19 Misfeed

    Thanks Spanky, you change these out as a set?

    Leave a comment:


  • spanky
    replied
    Re: Sharp MX6240N MX-FN19 Misfeed

    There are two pwb boards in the punch unit, one is an LED PWB the other a transistor PWB. They are at the entrance and are used for edge detection and jam detection. I replace these often for such issues.

    Leave a comment:


  • buzz
    replied
    Re: Sharp MX6240N MX-FN19 Misfeed

    ****UPDATE*****I ended up removing the Punch unit, and now the misfeed error on start up is gone. I think one of the sensors in the Punch unit is bad or blocked.

    Leave a comment:


  • buzz
    started a topic Sharp MX6240N MX-FN19 Misfeed

    Sharp MX6240N MX-FN19 Misfeed

    On Power up, Machine displays "misfeed occurred" in the finisher. Checked Sensor switching FED paper inlet ...etc. in simulation mode. Machine does not clear the jam indication unless I restart the copier. Updated to current firmware.
Working...