Scan to SMB for Windows Server 2012 R2

[samyeh]

Dear All,
Please help me to configure scan to SMB for Windows Server 2012 R2 step by step?
I know Sharp MFP cannot support SMBv3, so how to solve the issue?
Thank you very much.

[qbert69]

Re: Scan to SMB for Windows Server 2012 R2

Check your port number on the MFP that is used for scanning to SMB...I think Windows server 2012 R2 uses port 445 instead of 139. Make sure your MFP uses port 445 for scan to SMB!

[samyeh]

Re: Scan to SMB for Windows Server 2012 R2

Check your port number on the MFP that is used for scanning to SMB...I think Windows server 2012 R2 uses port 445 instead of 139. Make sure your MFP uses port 445 for scan to SMB!

Thank you very much for your kind reply,but still cannot use it!!

[spotlifter]

Re: Scan to SMB for Windows Server 2012 R2

The Old way - Install Sharpdesk.

The complicated way - https://support.microsoft.com/en-us/kb/2696547
(I don't know this link will help you or not but hope it lights up some ideas.)

[ruben]

Re: Scan to SMB for Windows Server 2012 R2

Scanning to local FTP could also be an option.

You will need to install an FTP server, e.g. FileZilla, create an authentication user, set the user's home directory as the scan folder, then allow FTP through the firewall. Should only take a few minutes to set up.

[JLSam]

Re: Scan to SMB for Windows Server 2012 R2

The Old way - Install Sharpdesk.

The complicated way - https://support.microsoft.com/en-us/kb/2696547
(I don't know this link will help you or not but hope it lights up some ideas.)

When sh*t hits the fan. Good ol Sharpdesk to to solve the problem.