[CQ] MX-2301 light prints

[aAandy]

Hello everyone

recently replaced drums, devs, charge kits & customer is complaining of faint prints, as if the devs have toned down - any suggestions?

also require latest firmware if anyone can help (andy@electrepairs.com.au)

many thanks

Andy

[JParker]

Re: MX-2301 light prints

How do the primary and secondary transfer belts look?

[driving lots of miles]

Re: MX-2301 light prints

I am assuming you have run all the color adjustments sims, I would then check the contacts where the drums connect to the back of the machine and make sure those are clean.