[Dead] SHARP MX-2310

[ivanusicnm@gmail.com]

Hi everyone,

I have trouble with Sharp mx-2310u.

During printing, machine stops and the control panel switch off. Only light obove on/off button is on. When I open the front door the control panel goes on, and appers warning (close the front door) and I can go to service mode. When I close the front door, the control panel goes to off and no response.The same think is with the side door.
I have replace SD-card, but no resoult. Proform SIM-14,16

Any Idea???

[driving lots of miles]

Re: SHARP MX-2310

Have you checked for a loose connection to the control panel?

[Craigcul]

Re: SHARP MX-2310

Hi There some of the older machines that the clutch wires shorted out and caused problems like that. technical report ARE996

[ivanusicnm@gmail.com]

Re: SHARP MX-2310

hi,

could you send me this tecnical report?

[Craigcul]

Re: SHARP MX-2310

ARE996.pdf
here Is that Technical report sorry I did not check messages.