MX-3050 F2-78 and "sensor calibration fr 06"

[RascalMJ]

Re: MX-3050 F2-78 and "sensor calibration fr 06"

Check the sensor target values for each color in sim 44-24, the values should generally decrease in value as the patch number gets higher. Messed up values ie.. K patch 13 is reading 100 when it should be in the 20-s to 30's will cause calibs to fail. if the values are out of whack I believe 44-21 will write new values. I had a mxm465 go double density on prts and copies, would also fail calibs, this fixed it for me.

These all check out fine. Thanks though

[mttech]

Re: MX-3050 F2-78 and "sensor calibration fr 06"

out of curiosity, did you update the firmware? I have had a couple of these machines go into that loop or just lock up when running 46-74, updated the firmware and went through the calibration process again, and all was well

[RascalMJ]

Re: MX-3050 F2-78 and "sensor calibration fr 06"

out of curiosity, did you update the firmware? I have had a couple of these machines go into that loop or just lock up when running 46-74, updated the firmware and went through the calibration process again, and all was well

I did when the problems first started, but I'll certainly look again and\or re flash the firmware.... It's worth a shot

Sent from my LG-LS998 using Tapatalk

[RascalMJ]

Re: MX-3050 F2-78 and "sensor calibration fr 06"

I did when the problems first started, but I'll certainly look again and\or re flash the firmware.... It's worth a shot

Sent from my LG-LS998 using Tapatalk

System currently has the latest firmware. I re-flashed just to make sure, but I'm not overly excited about the outcome once I get to testing.

[leo34staffs]

Re: MX-3050 F2-78 and "sensor calibration fr 06"

System currently has the latest firmware. I re-flashed just to make sure, but I'm not overly excited about the outcome once I get to testing.

Bit late to the party but what was the outcome??