MX-M904 Finisher Jams in the Saddle Fold entrance area.

[ZOOTECH]

Re: MX-M904 Finisher Jams in the Saddle Fold entrance area.

Try the finisher without the punch unit; I would be surprised if the jams still occurred. The punch units had a problem of 'gumming' up, and causing jams.

[acribari]

Re: MX-M904 Finisher Jams in the Saddle Fold entrance area.

ah ha, ok. I will get one delivered and try it out. I will keep you posted.

Thanks for all the help.

[acribari]

Re: MX-M904 Finisher Jams in the Saddle Fold entrance area.

Instead of fiddling around with the finisher, since it is a new install for the customer, I got another finisher with the same options. FN22 with Cutter, 3 hole, saddle fold and stitch. I removed the old one and installed the newer used one and it now works fine with no jams.


Thank you all for the input. I just could not keep the customer waiting so I had to just replace the entire finisher.


Thanks again.