4070 operation question

[Hansen88]

Hansen Front Office_20240823_144814.pdf Cust job is two duplexed 8 1/2 sheets with a half sheet corner stapled to it. The reason I dont know is because I never dealt with a customer using half sheets. I dont see how it can be done but you guys suprise me all the time. Basically seeing if they can have a drawer with the half sheets in it and have it print out and staple like this sample. Thanks

[ihatefinishers13]

Hansen Front Office_20240823_144814.pdf Cust job is two duplexed 8 1/2 sheets with a half sheet corner stapled to it. The reason I dont know is because I never dealt with a customer using half sheets. I dont see how it can be done but you guys suprise me all the time. Basically seeing if they can have a drawer with the half sheets in it and have it print out and staple like this sample. Thanks

I haven't tried that, but I'm going to go ahead and say it can't be done. There's no way for a finisher to align a half page and full pages accurately. You could try by setting it up in the driver, using "Inserts" and selecting Cover, telling it what tray to go to (I selected invoice paper in the bypass within the driver), and hit staple... But I just don't see it working.

[Hansen88]

Thanks for the reply. I didnt think it can be done either. Just checking incase something I didnt know about.

[ridgemill]

Perhaps landscape feeding orientation?

[Hansen88]

Perhaps landscape feeding orientation?

Thanks, I did try that as well. The half sheet jams in that direction.