Curl Adjustment

[boutn]

Where can i find some info on the Curl Adjustment option in the service login/paper settings section.

And what does the Fuser Pressure Setting do? It only has 0 or -5

image.png

[Hansen88]

I have not run into those adjustments before so I dont know. I wish they explained all the adjustments better. May have to do trial and error and see what happens.

[Michko]

I would love to know too


I made a paper but cannot find it anywhere.

[bilyahn]

Sharp used to have web interface training on their IDNC tech site but that was many years ago when the new (current) interface came out. It went through each screen step by step so might be something to look into to see if it is still there and has the information you are looking for.

Good luck

Bil

[tmw]

I haven't seen that page before. I have made temperature changes in the sim selection. I wonder if on the BPs is like on the phoenix 30/4070s etc. The output rollers have foam circles that have worn out or become compromised some way. Check if those need replacement.

[boutn]

I haven't seen that page before. I have made temperature changes in the sim selection. I wonder if on the BPs is like on the phoenix 30/4070s etc. The output rollers have foam circles that have worn out or become compromised some way. Check if those need replacement.

Thats not my question...and yes, you can also do this with the CR4 / 4.5 but the options are different, and i don't know what those options do either