If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
A Sharp MX-4071 with 15k on black and 34k on color that is giving K,C,M,Y error on simulation 44-26 and sim 61-11 all other calibrations are working, CQ looks good and firmware is up to date all OEM toners, etc. Any suggestions?
I've had a few instances where my 46-74 would give errors and 99% of the time it was the DV concentration wasn't good enough causing calibration errors. Maybe swap DV units just to get to see if it will calibrate?
I've had a few instances where my 46-74 would give errors and 99% of the time it was the DV concentration wasn't good enough causing calibration errors. Maybe swap DV units just to get to see if it will calibrate?
Comment