If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Just found out the ASM-Assist unit part # 0CWFM1N374019 can be used in these finishers. They are about half the price of the 0CWFM1P015020 units. Has anybody tried using these yet? What are the results?
Just found out the ASM-Assist unit part # 0CWFM1N374019 can be used in these finishers. They are about half the price of the 0CWFM1P015020 units. Has anybody tried using these yet? What are the results?
Haven't tried it yet. Just have to be careful, as there is also the FN12 for the 65ppm that even though the finisher is mostly the same, the part number could be one digit off and doesn't work with it.
Relevant pages from the two parts guide (EU) if you want to compare.
The only difference between FN27N and FN11 :
SHEET_ASSIST_EDGE_RUBBER
0CWFE358980//
0CWFE2B3190//
Comment