MX-2310U not booting

[euyulio]

Hi all, I think I have a corrupted SD card, would somebody be so nice give me a copy?

When i start printer after the logo animation I get this:

IMG_0698.jpg

after some seconds i get this:

IMG_0697.jpg

and it stays like this...

Thank you in advance

[mojorolla]

Re: MX-2310U not booting

Hi all, I think I have a corrupted SD card, would somebody be so nice give me a copy?

When i start printer after the logo animation I get this:

[ATTACH=CONFIG]61780[/ATTACH]

after some seconds i get this:

[ATTACH=CONFIG]61779[/ATTACH]

and it stays like this...

Thank you in advance

Looks like machine is in Emergency Update mode. There is a very small dip switch on the MFP board which turns this feature on.
There are a few threads on this forum, with picture, that will point you in the right direction.

[ihatefinishers13]

Re: MX-2310U not booting

Looks like machine is in Emergency Update mode. There is a very small dip switch on the MFP board which turns this feature on.
There are a few threads on this forum, with picture, that will point you in the right direction.

I think it's actually right next to the SD card, if I'm not mistaken. Could have been hit by mistake

[euyulio]

Re: MX-2310U not booting

Looks like machine is in Emergency Update mode. There is a very small dip switch on the MFP board which turns this feature on.
There are a few threads on this forum, with picture, that will point you in the right direction.

Thank you very much for your reply, the switch was in off position, if I turn it on, the screen goes from black direct to "update program init" if i leave in off it shows the animation and then goes to "update program init"
I tried to read the card on windows and mac both says "not initialized" with a partition software says it is empty... I guess it got corrupted

[euyulio]

Re: MX-2310U not booting

I think it's actually right next to the SD card, if I'm not mistaken. Could have been hit by mistake

THank you very much for your reply, yes it was exatly there but the machine was closed when it happened and nomobdy has opened it. I tried to move both switches and no change (it was in off) when i put it on it goes from black screen to the update screen if I leave in off it shows the start animation then goes to the update screen. I think the sd card is corrupted because it has no content, partition software says no bytes are been used.