Sharp Ar-m350 jams only in 2000 sheet lCF

[Wild Bill]

Hello,
Having jamming only when using the AR-20 LCF. It jams about 4 inches past the grey transport rollers of the LCF. I kept making a single copy until it finally jammed. It is very intermittent. Here is what I have done. Replaced all feed, sep and pre-feed rollers. (2 sets in LCF). Cleaned magnetic clutches in rear of LCF. (They looked clean but did it anyways. Question: Are there any bulletins on this for intermittent Jamming? Has anyone experienced this? Any help would be appreciated, thanks!!!

[mtech]

There is a bulletin about the clutches on the desk/lcc. They changed the clutches. New clutches are PCLC-0310FCZ1 and PCLC-0311FCZ1, not sure of the Qty's as it's been a while. ( the old clutches have the same number, but end in FCZZ) They also changed the follower springs on the lower left door. Old ones are silver and new ones are black. MSPRC2915FCZ2 is new, FCZ1 is old. I think what you are calling the lcc is either a D13 or D14 desk. This bulletin is pretty old, but it is something to check out. As usual with Sharp drive units, clean up the grease they slop all over! Hope this was helpful-Good luck!

[lky1978]

what is the jammed codes?sim 22-3 jam history, will help u alot