E1-00 code on Sharp AR-168

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • ebm
    replied
    Thanks to all who replied. Reached out to another dealer in my area and got the info to reprogram the counts.

    Leave a comment:


  • nightshade
    replied
    Got an email address?

    Leave a comment:


  • ebm
    replied
    Yes, it is a AR168D. Sorry for the confusion. I do not need to reset the counts to zero. I need the procedure to program the counts from the old board to the new one.

    Leave a comment:


  • nightshade
    replied
    By chance is it a AR-168D?

    Leave a comment:


  • just a tech
    replied
    this is from the ar-162,165,207 models ut will more than likely cross over to the ar-168 as well..they are in sim 24..
    24 01 Jam total counter clear
    02 Trouble memory clear
    04 SPF counter clear *2
    05 Duplex print counter clear *6
    06 Paper feed counter clear
    07 Drum counter clear
    08 Copy counter clear
    09 Printer counter clear
    13 Scanner counter clear
    14 SPF jam total counter clear *2
    15 Scanner mode counter clear ..hope this helps. good luck

    Leave a comment:


  • ebm
    replied
    Tried Sim 14 to reset, no joy. Also, tried to install firmware w/o success. Ended up replacing MCU PWB from another machine. Anyone, know the procedure to reprogram counts (total,pm,dv,drum)?

    Leave a comment:


  • cucuklotz
    replied
    HI,
    Have you tried resetting by a crop 14 simulation?
    Press Clear key, Interrupt key," 0 "key, Interrupt key,(display should go blank)Press "1" key ,press "4" key ,press start key.
    Hope this helps, ANDY

    Leave a comment:


  • nightshade
    replied
    Being at home and not looking it up, my first thought is replacing mirror base "A" otherwise called the scanner assy.

    But you could try reseating all the connections for the scanner especially the flat cable.

    Leave a comment:


  • ebm
    started a topic E1-00 code on Sharp AR-168

    E1-00 code on Sharp AR-168

    Anyone have a fix for this code? Turning off/on does not reset.
Working...