Hi all,
Have a mx6200. When you copy or print from any tray or bypass ,the lead edge void is around 9mm with none at trail, unable to adjust in sims. Everything on machine seems fine, good CQ and prints from machine however just this problem. Been advised to replace reg clutch. Have removed this and cleaned but did not make much difference, have ordered new one. Any one out there had this problem. All rollers nice and clean and firmware up to date.
Have a mx6200. When you copy or print from any tray or bypass ,the lead edge void is around 9mm with none at trail, unable to adjust in sims. Everything on machine seems fine, good CQ and prints from machine however just this problem. Been advised to replace reg clutch. Have removed this and cleaned but did not make much difference, have ordered new one. Any one out there had this problem. All rollers nice and clean and firmware up to date.
Comment