sharp 2300n factory reset

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • Doug.P
    replied
    Here is all I can remember about that old machine. I have attached a bulletin from 2012.
    Attached Files

    Leave a comment:


  • Guest
    Guest replied
    Hi tomasimattia , how did all end up for you on doing this factory reset? I am currently trying to do a factory reset on a MX-2300N without admin password at the moment. Any information or advice you can give?
    Thanks.

    Leave a comment:


  • sharphead
    replied
    Re: sharp 2300n factory reset

    We have one with 1,000,000 bw 200,000 colour going strong

    Leave a comment:


  • tomasimattia
    replied
    Re: sharp 2300n factory reset

    thanks all! i buy e service manual than i recalibrate the printer, just work fine! the printer have 500.000 copies and i think is near the end of life!

    Leave a comment:


  • JustManuals
    replied
    Re: sharp 2300n factory reset

    This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from


    Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


    Paul@justmanuals.com

    Leave a comment:


  • bilyahn
    replied
    Re: sharp 2300n factory reset

    I believe you will need to do sim 67-26 then 28 to reset the print values then you will need to perform 67-24.

    Standard Colour Calibration.pdf

    Here is the color calibration chart that should be followed.

    Good luck.

    Bil

    Leave a comment:


  • tomasimattia
    started a topic [Misc] sharp 2300n factory reset

    sharp 2300n factory reset

    Hi all, sorry for my english but i wrote from italy. I have a question. I have a sharp 2300n and a person change default value from sim code. for expample color, halftone.. etc.. etc.. i read your guide about calibration, and the printer di quite good. I need to reset alla parameters in the printe because there are same code probably different from default. tha amidnistatore reset does'nt reset really alla printer. i hope in your solution.
Working...