If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
sppd1_s jams, machine was on a dirty power line, i had the customer install a dedicated line but now i have these jams. i have replaced dspf control board but no luck. any suggestions?
That sensor is barley held in by the clips. Any jam removed backwards will knock the sensor out. Take the doc feeder apart and verify the sensor is seated properly.
sppd1_s jams, machine was on a dirty power line, i had the customer install a dedicated line but now i have these jams. i have replaced dspf control board but no luck. any suggestions?
Under the paper feed cover (sec #5, item #2 of the parts guide) there is a pwb with several connectors with cables that barely reach. I had one where the connector was not fully seated
and it gave all kinds of intermittent jams and/ or non operation.
"You can't trust your eyes, if your mind is out of focus"--
Comment