MX-3501N Sims 46-24 and 67-24

[draph]

Hope someone has seen this. When I perform 46-24 it never gives me the option to repeat. When I do 67-24 it will only let me repeat twice and then just says lay target on glass and press execute. This is after a full maintenance so everything is new. The last four I've done on this same machine I never had any problems with calabration.

If I proceed I end up with decent copies but terrible prints. Way too much magenta.

[tmaged]

Re: MX-3501N Sims 46-24 and 67-24

It doesn't give you an error, but it's not seeing something it needs to do the calibration. In my experience, it's usually yellow not present enough, and it's mainly caused by the primary transfer belt.