Sharp ar5623n network connection

[georgereth]

First time after installing the machine I try to connect it with the computer I use the CDROM and first thing to make is to give the IP adress to the nic card of the machine , during the progress ( to write the ip adress i have given to the machine) the power is cut for seconds .
After that it's impossible to write an ip adress to the machine . I run again the nic setup programm but it does not show the machine on the list
Any ideas how to solve this problem ?

[lky1978]

your network environment must to DHCP

[georgereth]

Re: Sharp ar5623n network connection

your network environment must to DHCP

it is read first
in the first time with the network scan tool i see the machine and i try to give the new ip adress , and in the writing progress to the copier the power is cut off . After that it is impossible to see the machine the network scan tool .

[lky1978]

you can reset the copier nic card by press and hold the reset button for 5-10secs, after that reboot.
normally i ll scan the copier ip address with sharp driver sc-scan A, if found the copier ip address, i ll log in the the copier web page and change the copier ip address.
username:admin
password:admin