lower cleaning roller

[rods]

What do you guys use to clean the lower cleaning roller in mx3100n

[MHeon71]

Re: lower cleaning roller

I would replace it. But if you have to clean it? I guess, I would try a knife or flathead screwdriver, if is seriously coated.

[axyun]

Re: lower cleaning roller

On a call when I don't have a replacement and metal cleaning roller is encrusted with toner I have used Blow OFF/Rubber Rejuvenator and paper towels or rag. Frank

[draph]

Re: lower cleaning roller

I first use a knife to scrape of the thick areas. Then I pull out the trusty 100 grit sandpaper I always carry.

[Akitu]

Re: lower cleaning roller

I remove the stupid cleaning roller altogether; does nothing but cause problems anyways.

[onetek]

Re: lower cleaning roller

I remove the stupid cleaning roller altogether; does nothing but cause problems anyways.

Lol .. so do I!

[draph]

Re: lower cleaning roller

Probably a pretty good idea after all.

[axyun]

Re: lower cleaning roller

That's an option I'll consider in future.Frank

[mojorolla]

Re: lower cleaning roller

I remove the stupid cleaning roller altogether; does nothing but cause problems anyways.

We have been doing this for years. Sharp should change the description to "lower destruction roller"

[igi]

Re: lower cleaning roller

We have been doing this for years. Sharp should change the description to "lower destruction roller"

if the waste toner bottle fails
the lower roller will collect