OCE CM2510 (Sharp MX2300)

[Reed]

This machine keeps showing a paper misfeed after it starts to warm up. It shows to remove paper @ POD1 and at the registration. But when I go into the service mode neither of those switches are highlighted as if there were some paper blocking them. I have simulated at jam at these areas and the machine will immediately show a jam upon start-up and doesn't try to warm up. The curious thing is the machine will cycle and warm up for a bit before showing the paper misfeed error. I have cleaned and tested all the sensors in the service mode. I have also reset the paper jam errors and it keeps shows there was a misfeed at POD1. Thanks in advance any help would be appreciated

[DavePo]

Re: OCE CM2510 (Sharp MX2300)

Replace the fuser unit. Or rebuild it with all the thermistors, also check the thermal breakers.

[Josh93]

Re: OCE CM2510 (Sharp MX2300)

Out of curiosity, what is the actual jam code? Pod_1N ect?

[Reed]

Re: OCE CM2510 (Sharp MX2300)

Yes, that was the exact code

Out of curiosity, what is the actual jam code? Pod_1N ect?

[Reed]

Re: OCE CM2510 (Sharp MX2300)

Thanks for the advice. I went out and rebuilt the fuser unit with thermistors. Machine still had the same problem I pulled out the fuser and checked the thermal breakers. I pushed the button on the back of one of the thermal breakers and I heard a snap. After that I had no more problems. I wouldn't have thought the thermal breakers would have caused this problem. But I am glad it worked!!

Replace the fuser unit. Or rebuild it with all the thermistors, also check the thermal breakers.

[Optima Family]

Re: OCE CM2510 (Sharp MX2300)

Hello Gentlemen,
Does somebody know if the OCE CM2510 & the SHARP MX2300N use the same toner cartridges?
Thank you.