Sharp ARM276

[Guest]

We are trying to bring this photocopier back online but nobody can remember the key operator code. We have tried 00000 but it must have been changed, so is there a way to reset it? Many thanks.

[DSallee]

We are trying to bring this photocopier back online but nobody can remember the key operator code. We have tried 00000 but it must have been changed, so is there a way to reset it? Many thanks.

hi,

You can go into service mode to display the key operator code.

To do this:

Press #
Press *
Press C (Clear)
Press *

At this point you should see a black box...

type in 22
hit Start key
type in 7
hit start key

You should now see the Key Operator Code.... WRITE IT DOWN!

To exit, just hit CA (clear all) a few times...

This should get you going...

Dave

[reyasuk]

hi,

You can go into service mode to display the key operator code.

To do this:

Press #
Press *
Press C (Clear)
Press *

At this point you should see a black box...

type in 22
hit Start key
type in 7
hit start key

You should now see the Key Operator Code.... WRITE IT DOWN!

To exit, just hit CA (clear all) a few times...

This should get you going...

Dave

Thanks very much for that, I'll try it first thing in the morning. You are a life saver!
Jen

[DSallee]

Thanks very much for that, I'll try it first thing in the morning. You are a life saver!
Jen

Glad I could help

If you are not a service tech, please be aware NOT to go anywhere else in service mode because you could mess things up a bit if your not careful. Just follow the steps, get the code then clear out of service mode.. you should be fine..

Dave