toshiba e-studio 453

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Orion2010
    Trusted Tech
    • Jun 2015
    • 176

    #1

    toshiba e-studio 453

    hello all, i have toshia e-studio 453 and i change drum and i clean all imagin unit now ??? any idea ?

    thanks



    IMG_0155.jpg
  • cpjim
    Technician
    • May 2015
    • 47

    #2
    Re: toshiba e-studio 453

    main charge is most likely the problem.

    Comment

    • blackcat4866
      Master Of The Obvious

      Site Contributor
      10,000+ Posts
      • Jul 2007
      • 22997

      #3
      Re: toshiba e-studio 453

      I'm leaning toward developing roller/bearings or developer bias contact. =^..^=
      If you'd like a serious answer to your request:
      1) demonstrate that you've read the manual
      2) demonstrate that you made some attempt to fix it.
      3) if you're going to ask about jams include the jam code.
      4) if you're going to ask about an error code include the error code.
      5) You are the person onsite. Only you can make observations.

      blackcat: Master Of The Obvious =^..^=

      Comment

      • NeoMatrix
        Senior Tech.

        2,500+ Posts
        • Nov 2010
        • 3514

        #4
        Re: toshiba e-studio 453

        I'd go with BC.
        Looks like a few metal staples/bearing shards shorting out contact for the dev bias.
        Inauguration to the "AI cancel-culture" fraternity 1997...
        •••••• •••[§]• |N | € | o | M | Δ | t | π | ¡ | x | •[§]••• ••••••

        Comment

        • Harry
          Trusted Tech

          100+ Posts
          • Feb 2009
          • 228

          #5
          Re: toshiba e-studio 453

          The Bias shaft is worn where the bias spring is attachet change or check magnet roller for por contact!
          Good Luck

          Comment

          Working...